32
Audio Design Associates
www.ada-usa.com
To Set Channel Delay Times:
1. Measure the distance in feet from your listening position to each of your home theater speakers. If
you have two subs, use the distance that is the average of both of them to your listening location.
2. Press and hold the Mode knob until the display changes to the Tone, Balance, and Volume recall.
3. Rotate the Mode knob until the cursor is flashing over the
P in PRO SETUP.
4. Press the Mode knob. The display will change to the Pro Setup menu.
5. Rotate the Mode knob until the cursor flashes over the
L in LEVELS.
6. Press the Mode knob. The display will change to the speaker level menu with the cursor flashing
over the D in DELAYS.
7. Rotate the Input knob to set the distance in feet that you measured in step 1 above.
8. Rotate the Mode knob to advance to the next channel for delay setting.
9. Repeat steps 7 and 8 for each channel.
Setup Menu Level Six – ADA Bus Menu Settings
The Suite 7.1 allows you to adjust communication settings and display settings once in the ADA bus
setup menu. The communication settings include setting the address for multiple Suite 7.1s is a single
system, setting the baud rate, and turning on and off the front panel IR receiver.
Setting the Address for the Suite 7.1
In larger systems, there may be multiple Suite 7.1s installed in the same system. In order to insure that
only the desired Suite is controlled on the same communication bus, it is necessary to assign different
addresses to each. If there is only one Suite 7.1 in the system, there is no need to change the address.
1. Press and hold the Mode knob until the display changes to the Tone, Balance, and Volume recall.
2. Rotate the Mode knob until the cursor is flashing over the P in PRO SETUP.
3. Press the Mode knob. The display will change to the Pro Setup menu.
4. Rotate the Mode knob until the cursor flashes over the A in ADABUS.
5. Press the Mode knob. The display will change to the ADA bus menu with the cursor flashing over
the B in BUS ADDRESS.
Setting the Baud Rate for the Suite 7.1
The baud rate determines how rapidly the communication bus transfers data. In most cases, it is best to
set the baud rate at 19,200 bps. However, in installations where you wish to control the Suite 7.1 with
a learning remote control, it will be necessary to change the baud rate to 1200 bps.
To Change the Baud Rate
1. Press and hold the Mode knob until the display changes to the Tone, Balance, and Volume recall.
2. Rotate the Mode knob until the cursor is flashing over the P in PRO SETUP.
3. Press the Mode knob. The display will change to the Pro Setup menu.
4. Rotate the Mode knob until the cursor flashes over the A in ADABUS.
5. Press the Mode knob. The display will change to the ADA bus menu with the cursor flashing over
the B in BUS BAUD.
6. Rotate the input knob to change the baud rate.
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Kommentare zu diesen Handbüchern